Pellet Fan
Pit Talk -- Comments and Questions Regarding These Pellet Pits => GMG => Topic started by: Jon515 on March 05, 2018, 04:16:55 PM
-
I saw a picture somewhere I can't recall where the GMG owner had drilled a hole through the pit & heat shield and ran a bolt through so they could adjust without taking everything down. Has anyone here done that or have a "how toâ€article they could share?
Thanks,
Jon
-
I have the first edition of the SS heat shield. I had to cut a bigger notch in it. I have been centering it from the sides which is about 1 3/8" from the right side.
-
Someone said they attached a 1/4" stainless steel rod to the heat deflector so they could adjust the heat deflector from outside the smoker. First you would need to drill a 1/4" hole through the outside of the smoker (use some high temp grill paint to prevent rusting), next to the grease drain and through the heat deflector. I remember seeing pictures of it at one time. I would use an all thread rod, put an nut on the inside and outside of the head shield to secure the heat deflector and put a wing nut on the all thread that is sticking out of the smoker. Probably would need to ensure it doesn't affect the folding tray on the side if it is a DB. I've actually thought about doing this, but the new heat shield I got has pretty much stabled my temps from side to side. Here is a pic of the old and new heat shield.