Pellet Fan
All Things Considered => General Discussion--Food Related => Topic started by: triplebq on December 12, 2018, 10:07:46 AM
-
OK I finally decided to give it a try. I'm in the process of doing a hot and fast brisket cook. My plan is 300 degrees for roughly 2 hours. I'm thinking the temp should be around 160 by then. Then into a foil pan with a can of beef consomme until 198-203. Not sure if I will do burnt ends. If so I will cube the point and back onto the pit for a couple of hours.
Will post the results.
My normal cook is 180 for 6-8 hours to get some smoke. Then wrap (foil or butcher), turn up pit to 230, and let it go until 198 or so. My normal cook tends to take around 14 hours on average.
-
I'm looking forward to your review of this method
I'm really curious if/how much smoke flavor you get (or don't get) compared to a long low cook :bbq:
I can see this working better with a stick burner than a pellet grill since the PG is a much more mild smoke flavor to begin with
please post pics too
-
I agree. I'm expecting the have less smoke flavor. Will post pics
-
Just pulled the brisket and separated the point and flat.
-
Initial impressions is the fat isn't rendered like I like it. The flat is resting and the point is back on the pit for burnt ends.
-
Initial impressions is the fat isn't rendered like I like it. The flat is resting and the point is back on the pit for burnt ends.
Did you cook to the same IT as low and slow? My experience with hot and fast is that it finishes at a higher IT.
-
Pics after slicing and some burnt ends. I must say I did like the taste. Not a lot of smoke which was OK. My wife and son loved it.
-
Initial impressions is the fat isn't rendered like I like it. The flat is resting and the point is back on the pit for burnt ends.
Did you cook to the same IT as low and slow? My experience with hot and fast is that it finishes at a higher IT.
I ended up going to about 205 which is hotter than I normal do. The total cook took about 5 hours for the flat. After pulling I put the point (burnt ends) ends back on for another 2 hours.
-
Which of your cookers did you use?
-
Which of your cookers did you use?
I used my Blaz'n Grid Iron.
-
So the big question is: what method of cook do you plan to use going forward?
-
So the big question is: what method of cook do you plan to use going forward?
I have a Wagyu brisket that I will be doing for Xmas dinner. I will be using the Low and Slow method. To me the fat is rendered down better when cooking it low. I must admit, going Hot and Fast isn't as bad as I thought.
-
So the big question is: what method of cook do you plan to use going forward?
I have a Wagyu brisket that I will be doing for Xmas dinner. I will be using the Low and Slow method. To me the fat is rendered down better when cooking it low. I must admit, going Hot and Fast isn't as bad as I thought.
I'm a 275° guy for just about everything "smoked". In fact, I don't think I use any different temp on my Memphis except 200° for jerky.
-
275 could be a great temp to try. I bet I would get more fat rendering like I like at that temp.