Pellet Fan
All Things Considered => General Discussion--Non food Related => Topic started by: Bar-B-Lew on June 13, 2020, 12:04:40 PM
-
So, I bought a used Blazin smoker a few years back and cleaned it up pretty good. Then, I let it sit outside the last year or so. Opened it up yesterday to think about using it for some wings and it has mold growing in it on the racks and the walls. I know I can clean up the racks with the power washer. Any thoughts on how to clean up the interior walls?
-
Put it on high and let er rip for about an hour.
-
I would also just burn it off. If you are worried about flaking, and you can see the areas. A quick hit with circular wire brush on drill afterwards.
-
Those of us with ceramic kamados have been told to monitor for mold. If found, we are to burn it at 600°F or so to remove it.
So, I'm with the people who suggest a high temperature burn and get back to cookin'.
-
Burn, burn and burn. I am in that camp.. If the grates are bad, brush + wipe after burning the nasties off.
-
I have had mold inside my Traeger at the summer cottage a few times when opening the place back up after the winter, I always just do the turn it on high for a pan hour or so and then give it a good brushing.
-
It depends on how much you like the smoker.
If you have desires for a new one you might be bale to convince the wife that it isn't safe to clean to mold out.
-
It depends on how much you like the smoker.
If you have desires for a new one you might be bale to convince the wife that it isn't safe to clean to mold out.
This is in the wrong section! SB in the how to buy a new smoker section.
-
It depends on how much you like the smoker.
If you have desires for a new one you might be bale to convince the wife that it isn't safe to clean to mold out.
Well, considering I already have 5 pellet grills with some of them being what I would consider the best available; I don't have a need to replace this one. It will be clean it up with as little effort as possible, or send it to the curb.
-
Mine get that way also at times. I mix up some white vinegar and water in a spray bottle and spray it and turn it on to 350ish and let it go, I may hit it with another spray or so while it is running.
If you are sending it to the curb give me your address. I wish I had known about Blazin before I bought my rec tec a few years back.
-
Mine get that way also at times. I mix up some white vinegar and water in a spray bottle and spray it and turn it on to 350ish and let it go, I may hit it with another spray or so while it is running.
If you are sending it to the curb give me your address. I wish I had known about Blazin before I bought my rec tec a few years back.
Hmmm...we are less than 5 hours apart from each other.
-
Mine get that way also at times. I mix up some white vinegar and water in a spray bottle and spray it and turn it on to 350ish and let it go, I may hit it with another spray or so while it is running.
If you are sending it to the curb give me your address. I wish I had known about Blazin before I bought my rec tec a few years back.
Hmmm...we are less than 5 hours apart from each other.
looks like maybe 4 hours. I am down by Johnstown.
-
To get rid of mold you can also spray it down with bleach and then burn off the remnants.
Then either run the pit real hot or use a weed burner.